Комментарий
https://author-alarm.atlassian.net/browse/TST-3920
https://author-alarm.atlassian.net/browse/TST-7216
https://author-alarm.atlassian.net/browse/TST-8087
https://author-alarm.atlassian.net/browse/TST-8579
Connect steering shaft locking module to Pin No. 4 in connector. Attention! During AUTOSTART work emerging of the caption "Engine start operation Error" on dashboard is acceptable.
Attention! On some cars equipped with a standard security system (SSS), when the central locking system is controlled via the A.Connect application, SSS goes into alarm mode.
When learning Autostart on a car, it may be necessary to physically disconnect the Igla from the car's electrical circuits.
The training is carried out with the installed and connected AUTOSTART module.
1. Switch on the ignition in the car.
2. Connect the gray wire to "+". The vehicle will be automatically recognized and indication signals will be issued to confirm that the module has learned.
3. Disconnect the gray wire from the "+".
4. Switch off the ignition.
5. Reset the power supply to the AUTOSTART module.
Changing Settings for Engine runing time with Accelerator and Brake pedal:
• Switch OFF the ignition.
• Press the ACCELERATOR pedal as far as it can go.
• Switch ON the ignition without starting the engine.
• Indication signals will be provided every 3 seconds.
• Release the accelerator pedal.
• To set the duration of engine operation, press the BRAKE pedal the appropriate number of times (see
programming table) with pauses no longer than 2.5 seconds. Every time you press the BRAKE pedal, it
is confirmed by the AUTOSTART indication signal on the dashboard. When the installation is finished,
wait for the repeated indication that corresponds to the programmed value.
• Switch OFF the ignition.