Комментарий

https://author-alarm.atlassian.net/browse/TST-7216 https://author-alarm.atlassian.net/browse/TST-8267

During the standard autostart session, the standard key fob does not work. You can only open the car with a key or a button (without a key). The external headlight indication operates when the parking brake is disengaged. Use the diagnostic equipment function for opening the central locking when the ignition is turned off. Attention! When autostart is working, the lock opening button on the standard key is not available. Active locks can be opened using the button on the door handle (Keyless) or using the driver's door cylinder. Attention! It is recommended to disable the function of automatically opening door locks when the ignition is turned off. Attention! External headlight indication operates when the parking brake is released. The training is carried out with the installed and connected AUTOSTART module. 1. Switch on the ignition in the car. 2. Connect the gray wire to "+". The vehicle will be automatically recognized, and indication signals will be issued to confirm that the module has learned. 3. Disconnect the gray wire from the "+". 4. Switch off the ignition. 5. Reset the power supply to the AUTOSTART module. Changing Settings for Engine running time with Accelerator and Brake pedal: • Switch OFF the ignition. • Press the ACCELERATOR pedal as far as it can go. • Switch ON the ignition without starting the engine. • Indication signals will be provided every 3 seconds. • Release the accelerator pedal. • To set the duration of engine operation, press the BRAKE pedal the appropriate number of times (see programming table) with pauses no longer than 2.5 seconds. Every time you press the BRAKE pedal, it is confirmed by the AUTOSTART indication signal on the dashboard. When the installation is finished, wait for the repeated indication that corresponds to the programmed value. • Switch OFF the ignition.