Комментарий

Connect steering shaft locking module to Pin No. 4 in connector. Attention! During AUTOSTART work emerging of the caption "Engine start operation Error" on dashboard is acceptable. Feature of this car: ATTENTION! When AUTOSTART is running, the car can be opened only by opening door lock manyally by car key, otherwise work of AUTOSTART should be interrupted. Changing Settings for Engine runing time with Accelerator and Brake pedal: • Switch OFF the ignition. • Press the ACCELERATOR pedal as far as it can go. • Switch ON the ignition without starting the engine. • Indication signals will be provided every 3 seconds. • Release the accelerator pedal. • To set the duration of engine operation, press the BRAKE pedal the appropriate number of times (see programming table) with pauses no longer than 2.5 seconds. Every time you press the BRAKE pedal, it is confirmed by the AUTOSTART indication signal on the dashboard. When the installation is finished, wait for the repeated indication that corresponds to the programmed value. • Switch OFF the ignition. If you press the BRAKE pedal once, it means the engine will work for 5 minutes. Second, third and fourth pressing add 5 minutes each. Fifth and subsequent pressings add 10 minutes to the duration time. For instance, if you want to set the duration for 20 minutes, press the brake pedal 4 times, and 8 times for 60 minutes.