Комментарий

[NOT TRANSLATED] https://author-alarm.atlassian.net/browse/TST-2079 https://author-alarm.atlassian.net/browse/TST-7635

ATTENTION! During the AUTOSTART cycle is not recommended to insert the key into the ignition, press the start/stop button and be in the cabin with the standard transponder key. For car key learning: 1. Switch ON Ignition. 2. Connect GREY wire to +12V in the car. 3. Quick Indication will star flashing (with interval 0,8 sec.). 4. Switch OFF Ignition and waite for 5 sec. 5. Switch ON Ignition. 6. Indication will change from Quick flashing to Slow falshing. (with interval 2 sec.). 7. Waite till the Indication change again to Quick flashing (it can take more that 1 minute). 8. Switch OFF Ignition and waite for 5 sec. 9. Switch ON Ignition. 10. Indication will change from Quick flashing to Slow falshing. (with interval 2 sec.). 11. Waite till the Indication stop for 3-4 sec. and after that will give out 1 flash. 12. Switch ON Ignition. Disconnect GREY wire. The car key learning is finished. After learning the car key, you need to enter the software update mode and use AuthorFlasher 3.2 to go to the "Key Calculation" section and follow the prompts in AuthorFlasher 3.2 Attention! 14 The autostart menu item must be enabled for the autorun to work correctly. Changing Settings for Engine runing time with Accelerator and Brake pedal: • Switch OFF the ignition. • Press the ACCELERATOR pedal as far as it can go. • Switch ON the ignition without starting the engine. • Indication signals will be provided every 3 seconds. • Release the accelerator pedal. • To set the duration of engine operation, press the BRAKE pedal the appropriate number of times (see programming table) with pauses no longer than 2.5 seconds. Every time you press the BRAKE pedal, it is confirmed by the AUTOSTART indication signal on the dashboard. When the installation is finished, wait for the repeated indication that corresponds to the programmed value. • Switch OFF the ignition. If you press the BRAKE pedal once, it means the engine will work for 5 minutes. Second, third and fourth pressing add 5 minutes each. Fifth and subsequent pressings add 10 minutes to the duration time. For instance, if you want to set the duration for 20 minutes, press the brake pedal 4 times, and 8 times for 60 minutes.