Комментарий

Время работы автозапуска зависит от настроек в меню автомобиля: 5, 10 или 15 минут. Чтобы изменить время работы, войдите в «Настройки», затем «Настройки автомобиля», «Дистанционный запуск», «Продолжительность» и выберите желаемую продолжительность Автозапуска, то есть 5, 10 или 15 минут. Чек-лист: Нет https://author-alarm.atlassian.net/browse/TST-7216 https://author-alarm.atlassian.net/browse/TST-8708

Attention! Buttons for Changing Settings - Passanger window UP (instead of Accelerator pedal) and Brake pedal. Attention! Before installing the AUTOSTART module in the car you should enable the Autostart in the car settings. To do this, use the official diagnostic scanner to change the 242 parameter in the BCM unit. Attention! During the autostart operation cycle, it is not recommended to insert the key into the ignition, press the start/stop button, or stay in the car with the standard key. Changing Settings for Engine runing time with Passanger window UP (Accelerator pedal) and Brake pedal. • Switch OFF the ignition. • Press the Passanger window UP. • Switch ON the ignition without starting the engine. • Indication signals will be provided every 3 seconds. • Release the Passanger window UP. • To set the duration of engine operation, press the BRAKE pedal the appropriate number of times (see programming table) with pauses no longer than 2.5 seconds. Every time you press the BRAKE pedal, it is confirmed by the AUTOSTART indication signal on the dashboard. When the installation is finished, wait for the repeated indication that corresponds to the programmed value. • Switch OFF the ignition. If you press the BRAKE pedal once, it means the engine will work for 5 minutes. Second, third and fourth pressing add 5 minutes each. Fifth and subsequent pressings add 10 minutes to the duration time. For instance, if you want to set the duration for 20 minutes, press the brake pedal 4 times, and 8 times for 60 minutes.