Комментарий

https://author-alarm.atlassian.net/browse/TST-8724

Attention! In cars with an indication of the sport mode of the gearbox on the dashboard, the following joint algorithm of operation of AUTOSTART and IGLA with labels is in effect: 1) if, when the autostart starts, the mark (smartphone) is in the needle’s visibility range, the engine will start for 2 seconds and stall with further cancellation of the autostart; 2) if, when the autostart starts, the mark is not in the visibility range, then the engine will start and run for the specified time When learning the key in Autostart on a vehicle, it may be necessary to physically disconnect the Igla from the vehicle's electrical circuits. Attention! During the autostart operation cycle, the inscription on the dashboard “engine start operation error” is acceptable. Training to produce when connected to IMO and IMI in parallel. The IMI break must be done after training. When learning, you must start the engine before connecting the gray wire to the permanent "+". The training is carried out with the installed and connected AUTOSTART module. 1. Switch on the ignition in the car. 2. Connect the gray wire to "+". The vehicle will be automatically recognized and indication signals will be issued to confirm that the module has learned. 3. Disconnect the gray wire from the "+". 4. Switch off the ignition. 5. Reset the power supply to the AUTOSTART module. Changing Settings for Engine running time with Accelerator and Brake pedal: • Switch OFF the ignition. • Press the ACCELERATOR pedal as far as it can go. • Switch ON the ignition without starting the engine. • Indication signals will be provided every 3 seconds. • Release the accelerator pedal. • To set the duration of engine operation, press the BRAKE pedal the appropriate number of times (see programming table) with pauses no longer than 2.5 seconds. Every time you press the BRAKE pedal, it is confirmed by the AUTOSTART indication signal on the dashboard. When the installation is finished, wait for the repeated indication that corresponds to the programmed value. • Switch OFF the ignition. If you press the BRAKE pedal once, it means the engine will work for 5 minutes. Second, third and fourth pressing add 5 minutes each. Fifth and subsequent pressings add 10 minutes to the duration time. For instance, if you want to set the duration for 20 minutes, press the brake pedal 4 times, and 8 times for 60 minutes.