Комментарий

https://author-alarm.atlassian.net/browse/TST-3920 https://author-alarm.atlassian.net/browse/TST-5356

Attention! On some cars equipped with a standard security system (SSS), when the central locking system is controlled via the A.Connect application, SSS goes into alarm mode. To disable the SSS, it is necessary by the dealer equipment to transfer the SSS control to a mechanical key (lock cylinder) and connect the SSS analog control. When learning the key in Autostart, a disconnection of IGLA from the CAN-bus may appear. The training is carried out with the installed and connected AUTOSTART module. 1. Switch on the ignition in the car. 2. Connect the gray wire to "+". The vehicle will be automatically recognized and indication signals will be issued to confirm that the module has learned. 3. Disconnect the gray wire from the "+". 4. Switch off the ignition. 5. Reset the power supply to the AUTOSTART module. Changing Settings for Engine runing time with Accelerator and Brake pedal: • Switch OFF the ignition. • Press the ACCELERATOR pedal as far as it can go. • Switch ON the ignition without starting the engine. • Indication signals will be provided every 3 seconds. • Release the accelerator pedal. • To set the duration of engine operation, press the BRAKE pedal the appropriate number of times (see programming table) with pauses no longer than 2.5 seconds. Every time you press the BRAKE pedal, it is confirmed by the AUTOSTART indication signal on the dashboard. When the installation is finished, wait for the repeated indication that corresponds to the programmed value. • Switch OFF the ignition. If you press the BRAKE pedal once, it means the engine will work for 5 minutes. Second, third and fourth pressing add 5 minutes each. Fifth and subsequent pressings add 10 minutes to the duration time. For instance, if you want to set the duration for 20 minutes, press the brake pedal 4 times, and 8 times for 60 minutes.