Комментарий

[NOT TRANSLATED] https://author-alarm.atlassian.net/browse/TST-7216 https://author-alarm.atlassian.net/browse/TST-7746

Attention! In cars with an indication of the sports mode of the gearbox on the instrument cluster, the following joint algorithm of the Autostart and the Igla with marks works: 1) if at the beginning of the autorun the label (smartphone) is in the visibility zone of the Igla, then the engine will start for 2 seconds and stall with further cancellation of the autorun; 2) if at the beginning of the autorun the label is not in the visibility zone, the engine will start and run for the specified time Attention! During the autorun operation cycle, the inscription on the instrument cluster "engine start operation error" is acceptable. The training is carried out with the installed and connected AUTOSTART module. 1. Switch on the ignition in the car. 2. Connect the gray wire to "+". The vehicle will be automatically recognized and indication signals will be issued to confirm that the module has learned. 3. Disconnect the gray wire from the "+". 4. Switch off the ignition. 5. Reset the power supply to the AUTOSTART module. Changing Settings for Engine runing time with Accelerator and Brake pedal: • Switch OFF the ignition. • Press the ACCELERATOR pedal as far as it can go. • Switch ON the ignition without starting the engine. • Indication signals will be provided every 3 seconds. • Release the accelerator pedal. • To set the duration of engine operation, press the BRAKE pedal the appropriate number of times (see programming table) with pauses no longer than 2.5 seconds. Every time you press the BRAKE pedal, it is confirmed by the AUTOSTART indication signal on the dashboard. When the installation is finished, wait for the repeated indication that corresponds to the programmed value. • Switch OFF the ignition.