Комментарий

https://author-alarm.atlassian.net/browse/TST-1513 https://author-alarm.atlassian.net/browse/TST-1520 https://author-alarm.atlassian.net/browse/TST-1522 https://author-alarm.atlassian.net/browse/TST-1524 https://author-alarm.atlassian.net/browse/TST-2080 https://author-alarm.atlassian.net/browse/TST-7216 https://author-alarm.atlassian.net/browse/TST-8403

Attention! When connecting autostart, the installer must enable point 14 on a car with a manual transmission, otherwise the car may drive if the gear is left in gear. For car key learning: 1. Switch ON Ignition. 2. Connect GREY wire to +12V in the car. 3. Quick Indication will star flashing (with interval 0,8 sec.). 4. Switch OFF Ignition and wait for 5 sec. 5. Switch ON Ignition. 6. Indication will change from Quick flashing to Slow flashing. (with interval 2 sec.). 7. Waite till the Indication change again to Quick flashing (it can take more that 1 minute). 8. Switch OFF Ignition and wait for 5 sec. 9. Switch ON Ignition. 10. Indication will change from Quick flashing to Slow flashing. (with interval 2 sec.). 11. Waite till the Indication stop for 3-4 sec. and after that will give out 1 flash. 12. Switch OFF Ignition. Disconnect GREY wire. The car key learning is finished. After learning the car key, you need to enter the software update mode and use AuthorFlasher 3.3 to go to the "Key Calculation" section and follow the prompts in AuthorFlasher 3.3 Changing Settings for Engine running time with Accelerator and Brake pedal: • Switch OFF the ignition. • Press the ACCELERATOR pedal as far as it can go. • Switch ON the ignition without starting the engine. • Indication signals will be provided every 3 seconds. • Release the accelerator pedal. • To set the duration of engine operation, press the BRAKE pedal the appropriate number of times (see programming table) with pauses no longer than 2.5 seconds. Every time you press the BRAKE pedal, it is confirmed by the AUTOSTART indication signal on the dashboard. When the installation is finished, wait for the repeated indication that corresponds to the programmed value. • Switch OFF the ignition.